What about any Linux distros for the DI? Just start over again. All submitted content is subject to our Terms Of Use. This not that hard Also please exercise your best judgment when posting in the forums–revealing personal information such as your e-mail address, telephone number, and address is not recommended. Is there any other setup i can try other than the above?

Uploader: Fenrill
Date Added: 25 September 2006
File Size: 70.55 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 56507
Price: Free* [*Free Regsitration Required]

Thus, through reasons of Social Engineering rather than merely “the most expedient technical solution, hardwiring” the two routers HAVE to be networked over wireless.

IF somebody who works at the Technical Division of any of those three entities could please answer the technical aspects of how to do it, using preferably the Setup Utilities within each of the devices, that would be a major breakthrough in communication.

Once I made these changes I had to reinstall the driver for the wireless card – which was a beta version set up specifically to run with XP -SP2 hope this helps It shows connected wired through modem to the router but no access to internet says, “The page cannot be diplayed”.

Yes, connecting both routers or simply the ethernet port on her Mac to the WRT54GS would be the simplest solution but she doesn’t want that.

Redhook Ars Tribunus Militum Registered: North of Albany NY Registered: The Cisco router is working great and all my arapter hosts are speeding right along thanks for the help Arsbut the Cisco does not have wireless. I’m a fairly skilled Techie myself, but this problem is kicking my gluteus maximus, hard fast and repeatedly.


DIssidwireless channel. Click the Advanced tab at the top and then click Performance on the left.

DI | Dlink products Configuration And Installation On D-Link Blog Home – Part 3

Extend SOHO internet connection to mobile devices offsite. I’ll never buy D-Link again.

How to hard reset D-Link Wireless linkwys to default settings? Using this setup, i can’t ping the pc’s that are connected to the 2wire, from my pc that is physically connected to thebut no internet. It doesn’t understand that the next hop router is out the LAN side This is possible but why?

Sun Dec 17, 1: I tried to point the gateway to the 2wire AND thebut no success as well.

WAP54G will not connect to a d-link DI-624 router with wep or wpa security enabled

Can someone please help me. The has a wan input, and 4 ports.

But the minute that I have any traffic destined for outside the network, the packets don’t go anywhere quote: Is there any “custom” firmware available that can trick the DI into believeing it’s an Access Point? To solve this problem we need to either uninstall the update or enable encryption in the wireless network in open key mode. Bud remember those devices are routers, they resolve the ips, each one know the IPs because are they function.


Super G will always be set to channel 6 but it actually uses most of the channel range between 1 and 11, which allows increased bandwidth. Uncheck the checkbox which says “Enable I had this problem on a DI also.

How to fix slow webpage load speeds on DIRL when used with some mobile devices?

Using D-Link DI as an access point only- Can’t get it to work right – Ars Technica OpenForum

I dunno if there’s any custom firmware floating around that reenables AP functionality. It’s definitely a solution! This is the same as saying, “I have a car with gas in it, but it’s not going to the grocery store”. Baseboard management controllers BMC vendors? The status light on D-Link router is flashing what is it indicating?

Click on the button advanced. Discussion topics include Wi-Fi setups, I tried to setup the DI as follows: